Hi folks. I obtained a pre-owned Anycubic Vyper. Alas, every print features defects in the surface as shown in the picture. It occurs in any type of material. Does anybody know the source of this type of defects?
You must log in or # to comment.
Wet filament. Or. Bad filament.
Those are bubbles. Try a dryer.
I already got myself a dryer as I suspected that. But this occurs in multiple filaments, brand new and older ones, different brands. To me it somehow feels like this is not the root cause… But I’ll keep an eye on that.
This is also my take on it.
My guess would be hotend not feeling so good. Those white spots look like result of temperature changes.
If you can read hotend thermistor data somehow (OctoPrint, for example, shows a chart for that) and see lots of sudden ±2-5°C changes - that’d be it.
Yeah, that’s what I observe in octoprint. Do you also know how to fix?
You can try running a PID tune on the nozzle and see if that helps.
Unfortunately, the temperature variation still is above 3° C.
Ok, I never heard of that and read into it. As this is there easiest thing to do, I’ll do this ASAP and see of it works.
This might be thermistor losing contact with the block or wires losing contact. It can also be the heater wires losing contact somewhere. To diagnose, you can try and wiggle the wires when you preheat the hotend and watch the temps. Then you will know what needs replacing. I once had a thermistor that was faulty, I replaced it, the problem went away.
Replace the resistor and temp sensor. I would also replace the hot end itself, at least for my printer it was like 10e
Weeeeeeell the last time when I tried to replace the hot end, I screwed up so hard the printer was not usable any more after that 😂
How…? Mine is literally 2 bolts and the bowden tube retaining bolt? Plus of course the sensor and resistor cartridge. I have no experience of direct feed hot ends tho.
Guess I have been repeatedly too stupid to buy parts up to specs and then trying to solder them together, which failed. By that, I destroyed the original equipment and got no working replacement in place.
I got results kinda like that before when I tried a Volcano on an old Bowden style printer and printing wet PETG… Tons of oozing.
Well, the PETG is brand new and I use a heated chamber for the filament, so I really hope this is not the case. But as the setup sits in a basement, I’ll try to check that, too.
Do not underestimate PETG’s moisture absodbage it can also get too wet (theoretically, personally hasn’t happened but I don’t keep my filament for long before printing) if it is even sealed as most bags aren’t 100% airtight IIRC.
That is true. That is why I bought that filament drying chamber. I’ll keep an eye on that.
Did you listen to it print? If it’s really wet sometimes you can hear a cracking sound as the moisture boils off. It causes little steam pops, which also result in that scrappy surface finish.
Yeah I keep an east on the print at times, but I don’t hear that noise. But I am aware of it from prior endeavors with wet filament
