• 0 Posts
  • 11 Comments
Joined 3 years ago
cake
Cake day: September 29th, 2023

help-circle

  • The rest of the print is perfectly fine but the top layer is having issues? I would check the settings that effect only the top or top / bottom layers.

    You said it’s a new filament, is it a new profile for the new filament as well or have you successfully printed other filaments with the exact same settings?



  • Have you adjusted your flow rate? Slicers are usually pretty close to spot on for 0.4mm nozzles but in my experience going up or down in nozzle size usually results in having to change the flow % pretty significantly. In addition to what others have said about minimum layer time / heating the parts up too much, I think you may be over-extruding as well.

    The test I like for testing flow is to print a handful of cubes ~15 layers tall, with 2 bottom layers, 3 infill layers, and 10 top layers. Print each one at a different flow rate (in cura you can change settings per part to print them all at once) and look at the top layer when it’s done. You don’t want any bulging from between print lines (over-extruding) or any gaps in between them (under-extruding).




  • papalonian@lemmy.worldto3DPrinting@lemmy.world•Who's next
    link
    fedilink
    English
    arrow-up
    32
    ·
    2 months ago

    The article mentions four patents:

    9,168,698 / 10,556,381 - Force detection on the printhead, ie when your printer homes the z-axis by touching the nozzle against the build plate (would not include conductive or magnetic sensors)

    9,421,713 - Using purge towers in prints with multiple filaments or extruders

    7,555,357 - Not really sure exactly what this describes, so here is the patent’s abstract:

    A method of forming a three-dimensional object using an extrusion-based layered deposition system, the method comprising generating a build path for building a layer of the three-dimensional object, where the build path defines a void region. The method further comprising generating at least one intermediate path in the void region, and generating a remnant path based at least in part on the at least one intermediate path.

    Seems to include slicing objects that are not completely solid on the surface (ie a cube with a hole through the center).

    So, with this precedent, Stratasys can go after… nearly every printer on the market. Cool