I don’t remember seeing them do any specific sponsored content, though they may and probably have, but that have a very open affiliate program that every 3d printer youtuber I’ve seen is in. They also give out codes for streaming channels to give away filament.

All this I’m saying is I don’t think they’re “choosing” these channels but I doubt they care what the content in on any channel.

I think your belt paths is going to give you inaccuracies. I’m looking at the belts behind your x/y joints and the belts aren’t parallel there. I can’t remember exactly why that’s bad but I think it ends up with uneven movement across the entire motion range.

I’m not exactly 100% sure on this but I’ve seen people mention similar issues to people doing ender 3 switchwire conversions.

It might even out because it seems like you have the same thing on both both belts behind the gantry but I would look into that.

Nah he can sell it and put it in an account in a qatari bank that the government may or may not control. That counts as we right?

Op is clearly a couch and has been personally victimized by the VP.

I remember seeing a YouTube video (that I might search for and find again if I remember) where some company had developed (and probably patented) an approach that involved inkjet-coloring as it printed.

This is HP and their Multi Jet Fusion or MJF line.

I did this once on my ender 3, same no issue to the mag sheet but I cancelled the print only a couple layers in.