Its a slight tweak of the profile I use with other sunlu pla filament.

I’ve tried to top layer setting tweaking bit not luck so far

Thanks for the tip

Might have to save this as a last resort 😅

Sorry?

Thinks for the tips

There’s a massive blob stuck round the thermistor wires that is detached from the hot end. Tried to melt the blob but cant get the middle to heat up.

If the wires do get broken are they easy to replace ?

Made a lot of progress but it is in the screwheads the attach the hot end. Ridiculous

Looks to be about £30 I think. Although looking at the service video I can’t actually get to the screws to remove the hot end because they are covered in pla